No license is granted by implication or otherwise under any patent or patent rights of Western Digital.Western Digital reserves the right to change specifications at any time without notice.Avoid touching the circuit board components on the bottom of the hard drive.
![]() Western Digital Wd10Eads Jumper Settings License Is GrantedDo not stack hard drives or stand your Western Digital hard drive on its edge. Western Digital Wd10Eads Jumper Settings Code Are OnThe complete serial number, model number, and date code are on the large label at the top of the drive. This information is required for technical support purposes. Jumper Settings Western Digital Serial ATA hard drives ship from the factory with a jumper shunt in the Default position (across pins 1 and 2). It is not necessary to move the jumper shunt on the drive for workstation or desktop use. When using the Western Digital SATA cable, you must also attach the legacy ATA 4-pin power connector to the SATA drive. If instead you use a standard SATA interface cable (not included) on the SATA drive, DO NOT connect both SATA power cable (not included) and legacy power cable at the same time or the drive will malfunction. If you have an older system, it may be necessary for you to either upgrade your system BIOS or configure the current BIOS so that the new drive will be properly detected. Western Digital provides Data Lifeguard Tools to assist with hard drive installation, management, and diagnostics. Depending on your setup and configuration, you can use either the Windows or DOS version of Data Lifeguard Tools. Note: The model number for your hard drive is printed on the label located on the top of the drive. If you wish to create customized partitions, select the box to change advanced options and check Custom Partition. Select Installation Type as Add the drive as an additional device. The Custom Partition Setup screen appears. Your hard drive is automatically partitioned to the largest capacity up to 137 GB based on your operating system limitations. Click Done to exit Data Lifeguard Tools. Remove the CD and restart the computer to use your new Western Digital hard drive. ![]() It is not necessary to move the jumper shunt on the drive for workstationdesktop use. Your new Western Digital Serial ATA drive should be listed as a SCSI Disk Device or Serial ATA Disk Device. If not, make sure that all cables are securely attached and that your system BIOS has been properly configured. Contact Support - Contact our support representative by phone or e-mail.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |